How to Send CURRENT ECU File and Request SFT Tune for *NON STOCK ECU*
FIRST Please watch these 2 short videos
|
|
|
|
Protocol 124 - How to Read ECU Data:
1.Open USB over Network and connect to server 1, 2, or 3 2. Connect clear SFT ECU device to vehicle and Laptop 3. Turn ignition switch to run position (DO NOT START ENGINE) 4. Bit Box > "Select vehicle/ECU" button > select FID 124, then press ok. 5. Press the "READ" button, follow key on off prompts, and read your CURRENT ECU map file (this will take 10 min). Fill out Form (See example Below) PLEASE include First/Last Name & Stage 1 or 2 in the comments box Press "Send" to Submit File |
Protocol 107 - How to Send ECU Request:
1.Connect to server 1, 2, or 3 in USB over Network 2. Connect clear SFT ECU device to vehicle and laptop 3. Turn ignition switch to run position (DO NOT START ENGINE) 4. OBit Box > "Select vehicle/ECU" button > select FID 107, then press ok. 5. Now press the "READ" button, it will say "No file found on server, send to your master anyways?" Say "yes" Fill out Form (See example below)
PLEASE include First/Last Name & Stage 1 or 2 in the comments box Press "Send" to Submit File. **That's it! The box closed and your request was sent. No further confirmation will be observed. ** It's normal to see , "FILE ON SERVER COULD NOT BE FOUND" |
* PLEASE DISCONNECT FROM SERVER WHEN DONE *
|
|
|
*Allow 72 hours before asking "Did you get my ECU Request?*
If you need assistance please email [email protected]
If you need assistance please email [email protected]